Klipper x y offset. Moved my probe. This is based on the instructions found at: What you're needing to do, is tell the printer the relationship between the two. Once calibration is complete, one may use all the standard Klipper tools that use a Z probe. When calibrating z_offset using a probe, Klipper doesn't use x_offset and y_offset to move the nozzle head to the same point on the bed as the probe. Update the printer. New offsets x 33mm, y 23mm. So you define the endstops in _relation_ to 0,0. You'll need to adjust your position_min, position_max, and position_endstop for x and y in the klipper config. If either the x_offset or y_offset is modified then be sure to run the PROBE_EDDY_CURRENT_CALIBRATE command (as described above) after making the change. Both the position max (X & Y) and slicer bed size need to be correct and matching. f1ru lxtp jpay1gy lnw0 eju3 xz0 n71 7vmxc ra4 l7ru